Hi,
In the task 3(Peg in the hole) the diameter of the peg and the hollow part are given to be the same. What is the tolerance value between the peg and the hole?
Regards,
Ninad
Task 3: Tolerance Value
2 posts
• Page 1 of 1
Task 3: Tolerance Value
by ninad.manerikar » Mon 21. Jul 2014, 08:35
- ninad.manerikar
- Posts: 3
- Joined: Mon 21. Jul 2014, 08:23
Re: Task 3: Tolerance Value
by fabrizio.caccavale » Mon 21. Jul 2014, 09:37
Dear Ninad.
Thanks for your question, which is very relevant.
The tolerance is 2 mm (parameter Tp in Table 1 on page 34), i.e., the hole's diameter is larger than the nominla one. The diameters in figure 20 are the nominal ones: this might be misleading and will be clarified in future versions of the technical annex.
Best regards.
The EuRoC team.
Thanks for your question, which is very relevant.
The tolerance is 2 mm (parameter Tp in Table 1 on page 34), i.e., the hole's diameter is larger than the nominla one. The diameters in figure 20 are the nominal ones: this might be misleading and will be clarified in future versions of the technical annex.
Best regards.
The EuRoC team.
- fabrizio.caccavale
- Posts: 8
- Joined: Tue 15. Jul 2014, 10:16
2 posts
• Page 1 of 1
Return to Stage 1 - Simulation
Who is online
No registered users
Powered by phpBB® Forum Software © phpBB Group
Bei iphpbb3.com bekommen Sie ein kostenloses Forum mit vielen tollen Extras
Forum kostenlos einrichten - Hot Topics - Tags
Beliebteste Themen: Cam, Uni, NES, Software, Mode
Impressum | Datenschutz
Bei iphpbb3.com bekommen Sie ein kostenloses Forum mit vielen tollen Extras
Forum kostenlos einrichten - Hot Topics - Tags
Beliebteste Themen: Cam, Uni, NES, Software, Mode
Impressum | Datenschutz