EuRoC Forum

by **neek** » Tue 30. Sep 2014, 18:32

Hello all,

I was wondering how one is supposed to rivet the lower holes on the workpiece: they are just ~1cm above the table top, and the lowest margins of the "protruding" parts of the end-effector that I could find are about 1.3cm. I tried to illustrate the problem on the screenshot attached.

Kind regards,
Nikita

by **Advertising** » Tue 30. Sep 2014, 18:32

by **admin** » Mon 13. Oct 2014, 14:30

Dear Nikita,

We are preparing a new workpiece with better approachable holes. I will post a notification when it is available for download.
Please note that the hole positions will change anyway for the final evaluation.

Best Regards

EuRoC Forum

Task 2: Lower holes of the workpiece

Task 2: Lower holes of the workpiece

Re: Task 2: Lower holes of the workpiece

Who is online